Posts Tagged ‘Passap Placemat’

Passap vs Brother Placemat by Tricia Shafer


DSCF3915

DSCF3920

I made this  Tricia Shafer plated place mat(top picture)  on the Brother years ago and I liked it. I decided to make it again. When I finished, I decided to try to duplicate it on the Passap. And that is when I found out I can’t. (Notice , I said “I can’t” , maybe someone else can) I also found out from a friend in Arizona that there is a plating attachment for the passap, though rare to find.

I made the placemat on the Brother with two strands of Estillo for both yarns . On the botton one made on the passap I used one strand of Diamonte. I tried two strands of Estillo to start and I think I had problems because I did not have the right tensions. Looking back now, I bet it would be the same size as the first one if I did use the 2 strands of estillo.

Here are the comparisons . The plated mat is heavier and had a great shape when it came off the machine.  The passap was made just using blue diamonte using the same amount of stitches . The passap mat is smaller by about one and a half inches but it still is a nice size. The passap mat is not as nice shaped and is much lighter. The pattern came out nice on both mats done on different machines. So, I have to give the vote to Brother just because I don’t have the plating attachment for the Passap. 😦

To make this on the passap, I cast on N/N 1/1  and knitted the two CX 2../2.. rows and the N/N 5/5 row and then I transferred stitches from the front bed to the back bed.

Below is the  set up on the front bed.(of course you will have more needles than the diagram) The ends have 2 needles in work . The dots are the needles out of work.The back bed has all of the needles in work and the racking handle is down while knitting. You will put it up when transferring the stitches so the needles line up at the beginning transfers.

I cast on 63-63 on front bed and one less on back bed so the end needles are on the front bed. After transferring the front bed stitches to the back bed,(if you have one left over double up the stitches so that both ends look like the diagram below) put those needles out of work and put pushers in work under the remaining needles in work. Set locks to LX/N. I set the back bed tension to 5 and the front bed tension to 3. On the Brother the tensions were 7 on the main bed and 3 on the ribber. The sequence is six rows of knitting at LX/N and then 2 rows of LX/GX so that only the front bed needles knit.ALSO:in her pattern , Tricia  only does two rows of knitting instead of six between the  rows , two times,and you can see that in the pattern. There are three lines close together dividing the mat in 3. There are 158 rows of knitting . To finish transfer the front bed stitches to the back bed and bind off the stitches.

11.1.111.1.1.1.1.1.111.1.1.1.1.1.111.1.11